Check work offset, tool geometry and wear values before the first cycle.
A correct program can still collide when the work origin, tool geometry or active offset does not match the actual setup.
Recommended order
Separate tool geometry, wear compensation and work offset. Document the physical reference represented by each value. Confirm workholding and jaw projection, tool and T-offset selection, and X/Z work origin using the machine’s approved procedure. Check the path in simulation; simulation alone cannot validate the real workholding or offset values.
First run
Use the approved proving procedure with suitable reduced overrides, verified clearance and single block where applicable. Feed hold and single block have machine-dependent limitations and are not substitutes for a safe setup. Stop if position or active mode is uncertain; do not improvise offset corrections during an uncertain approach.