Trace chatter through the rigidity chain before changing cutting data.
Turning vibration is not always solved by reducing speed. First inspect the stiffness chain, then change one factor at a time.
Stiffness chain
Check workpiece, chuck, jaws, tailstock where applicable, holder, turret and overhang. Reduce unnecessary projection, verify seating and tightening, and use suitable support only through an approved setup. Do not exceed workholding limits.
Read the marks
Regular waves may suggest resonance; marks appearing as the edge deteriorates may point to wear. Vibration limited to a diameter can reflect changing dynamic conditions. Treat these as hypotheses and compare them with the recorded process.
Controlled adjustments
Within approved ranges, try a deliberate speed change and record the result. Then review feed, depth and tool geometry. Avoid changing several parameters at once. Stop when the process becomes unsafe or quality fails, and follow the workshop’s restart procedure.