When to use constant surface speed or fixed RPM on a Fanuc lathe.
G96 changes spindle RPM as cutting diameter changes to maintain the programmed surface speed. G97 sets fixed spindle RPM. Choosing the correct mode helps control speed and cut stability.
G96: constant surface speed
In metric mode, n = 1000 × Vc / (π × D), with Vc in m/min, D in mm and n in rpm. At smaller diameters the requested speed rises. A configured spindle limit can prevent the requested cutting speed from being reached.
Set and check the spindle limit using the command documented for your machine. On controls that use G50 S for this purpose, define it before G96. Never choose the limit from an example: chuck, jaws, workpiece and machine limits all apply. Confirm units and diameter interpretation.
Numerical example
At Vc = 180 m/min and D = 100 mm, theoretical speed is about 573 rpm. At D = 20 mm it is about 2865 rpm. With a hypothetical 2500 rpm ceiling, actual cutting speed at D = 20 mm would be about 157 m/min. These are mathematical examples, not validated cutting parameters.
Mode illustration, not a complete machine program
The following block illustrates commands only. It omits tool selection, offsets, feed mode, workholding and the cutting path. Confirm your control manual, prove the setup and simulate before any execution. No safe approach or complete operation is implied.
G50 S2500
G96 S180
G97 S800When to use G97
Fixed RPM can be appropriate for axial drilling or cycles that require it. Driven tools and rigid tapping depend on the machine and cycle: do not assume one command applies to every spindle. Under G97, S specifies spindle RPM. Check rotation direction. Changing G96/G97 does not by itself prove that the required feed mode is active.
Check before machining
Verify the active spindle, units, work origin, tool geometry, clearances and maximum permitted speed. Check the selected feed mode and the meaning of F independently. Use the approved workshop proving procedure.
Manufacturer references (Haas control; verify your own Fanuc configuration)
Haas · G96Haas · G97